"A Good Way To Bend Wiremold:""A Good Way To Bend Wiremold:"
From: GR Friscia Lightman83@aol.com
When bending wiremold around obstructions, mouldings, casings,box-offsets, lay the wiremold in it's place unbent and mark the bend as you would regular conduit. Then use wood blocks to fabricate the obstruction, moulding, offset etc. Then form the wiremold using a rubber mallet. This will work on most bends, and saves your scrap pile from getting too high.
If you have any Tricks of the Trade you would like
to add or if you have any comments please feel free to Email E.T.E..
