"5/16 Nutdriver for wirenuts:""5/16 Nutdriver for wirenuts:"
From: E. D. Blacker bender_1971@yahoo.com
If you are doing a lot of splicing with wirenuts, use a nut driver! The 5/16 works very well for the tan Ideal wirenuts. Try other sizes for other types of wirenuts. This is cheaper than going out and buying one of the specialty tools for this purpose, and it's one less tool in your pouch! Besides, the ground screws are normally 5/16 anyway, so you should already have one on you! Your fingers will thank you.
If you have any Tricks of the Trade you would like to add or if you have any comments please feel free to Email E.T.E..
