
April 2004
Test your knowledge of the code, by taking E.T.E.'s code quiz.
There are 10 questions, which are multiple choice.
Based on the 2002 Code Book.
Question #1:
Can a general use AC snap switch be used as a disconnect for a motor load?
(A) Yes
(B) No
Question #2:
The conduit or raceways, including their end
fittings, shall not rise more than ___ inches above the bottom of
the enclosure.
(A) 3/4
(B) 1
(C) 2
(D) 3
Question #3:
Infrared lamp commercial and industrial heating
appliances shall have overcurrent protection not exceeding __ amperes.
(A) 20
(B) 35
(C) 50
(D) 55
Question #4:
Unless protected by groundfault
circuit-interrupter protection for personnel, the secondary winding of the
isolation transformer connected to the impedance heating elements shall not have
an output voltage greater than ___ volts ac
(A) 12
(B) 24
(C) 30
(D) 120
Question #5:
The ultimate trip current of a thermally
protected motor rated at 9 amps or less shall not exceed ___ percent of the
motor full-load current.
(A) 125
(B) 150
(C) 170
(D) 180
Question #6:
For a wye-start, delta-run connected
motor-compressor, the selection of branch-circuit conductors between the
controller and the motor-compressor shall be permitted to be based on ___
percent of either the motor-compressor rated load current or the branch-circuit
selection current, whichever is greater.
(A) 25
(B) 58
(C) 67
(D) 125
Question #7:
The total marked rating of a cord-and
attachment- plug-connected room air conditioner shall not exceed ___ percent of
the rating of a branch circuit where lighting outlets, other appliances, or
general-use receptacles are also supplied.
(A) 10
(B) 20
(C) 35
(D) 50
Question #8:
Single-phase
cord-and-plug-connected room air conditioners shall be provided with
factory-installed LCDI (Leakage Current
Detection) or AFCI (Arc Fault Circuit )
protection. The LCDI or AFCI protection shall be an integral part of the
attachment plug or be located in the power supply cord within __inches of the
attachment plug.
(A) 4
(B) 6
(C) 12
(D) 18
Question #9:
Overcurrent protection shall not be required for
conductors from a battery rated less than ___ volts if the battery provides
power for starting, ignition, or control of prime movers.
(A) 25
(B) 50
(C) 60
(D) 75
Question #10:
A means shall be provided to reduce the residual
voltage of a capacitor to 50 volts or less within ___ ___ after the capacitor is
disconnected from the source of supply.
(A) 30 seconds
(B) 1 minute
(C) 3 minutes
(D) 5 minutes
Thanks for taking E.T.E.'s Code quiz!
If you find any discrepancies please feel free to email E.T.E. at
http://www.elec-toolbox.com/email.htm.
Back to ETE's Code Quiz Page
Back to Main Page
2004, Electricians' Toolbox
Etc...

Design by
TC